• Graco InvisiPac GS35 Slim Single Module Applicator
  • Graco InvisiPac GS35 Slim Applicator Diagram

Graco InvisiPac GS35 Slim Single Hot Melt Module

Graco InvisiPac GS35 Slim Applicator Overview

The Graco GS35 slim single module applicator offers a smaller footprint than the traditional GS35 applicator unit. The GS35 slim applicator was designed to eliminate hot melt clogging allowing for higher up time and reducing overall operating costs. 

The Graco GS35 Slim offers was engineered with an air open/spring close ball and seat allowing for greater than 3,500 cycles per minute. 


Engineered for optimal control and with high speed and high temperature applications in mind.

Module Spring

The GS35 Slim applicator module comes with a factory set spring that works across all pneumatic and fluid pressure ranges which means there is no need for fine adjustments. 

GS35 Module Filter

This module filter was engineered to protect the ball and seat from char and debris creating a clog free system.

The Manifold

The Manifold on the GS35 Slim applicator traps residual char or debris which is then removed when the filter is changed. The manifold filter is placed in a heated zone which means no cold spots so you have consistent dispensing. 

Finally, the manifold can be brought up to heat in 10 minutes. 

* Both the InvisiPac GS35 and GM100 Plug-Free applicator have 2 different RTD options:
  1)  Pt 100(385) is a Platinum 100 ohm RTD. 
  2) Ni 120 is a Nickel 120 ohm RTD.

The name plate on the applicator will list which one to pick on the delivery system. If you pick an incorrect selection, the applicator may not heat properly or it may be damaged. Remember to specify the type of RTD in use on the Display Module.


$0.00   On Sale
Buying in bulk? Request a volume quote